Overvolted HDD

WD External and Portable SSD All Other External SSD
1

I accidentally grabbed the wrong module PSU cable, one for a different PSU and I think I have blown the TVS Diode on two HDD

Any chance I can save these drives? Can I remove the diode and they will work again? I’ve little experience with soldering or using a multi-meter, although I do have both.
Drive 01: 4tb

IMG_7624
IMG_76241920×1080 211 KB

Drive 02: 10TB

IMG_7629
IMG_76291920×3413 476 KB

2

Measure the resistances of the two TVS diodes (SUA and Y4/Z4) and the two fuses (“S”).

3

I might not be doing it right

I get this for both SUA and Y4. It just says 1. if I reverse it. i GET .001 for the fuse on the left and .001 if I reverse it as well. I get nothing for the fuse on the right. This is the same across both boards

IMG_7636
IMG_76361920×3413 613 KB

4

okay so its definitely the 5v fuse

5

Bridging the ends of the fuse with a blob of solder will probably get you going, but you need to decide whether you accept the risk. If you have the necessary soldering skill, you could replace the fuse, in which case a 2A rating should suffice.