Re: Sansa Fuze+ Firmware 02.38.06 Manual updating failure

Hi all,

Today I have got a Sansa Fuze+ and I wanted to do a Manual update to 02.38.06. I did it following the instructions found in this official site ( but when I turn it on again, there were these black screen with small letters and I can not start my Fuze+ again!! what can I do to restore it? I tried it all. Only could start by pressing Volume Down button plus On/Off button but that is annoying. Please, help. Thank you. Luis from Argentina

Do a reset by pressing and holding the power button for 20-30 seconds. Release, then press it again to power it up.