I’ve just completed a clone operation with the new USB 3.0 controller.
The clone operation completed without errors.
I did not test with a SanDisk Ultra II SSD since I RMA’d them back to the vendor of purchase.
I did test with a SanDisk Ultra flash drive which would give me a “failed to start” in any USB 3.0 port.
Now, However, with the new controller, the flash drives are recognized and insert properly.
I will assume that the controller card was outdated since it was 5 years old or older and that
the new controller card will function properly with the SanDisk Ultra II SSD’s.
I will consdier this thread resolved. If I run into any new issues with the new controller I will report back.