Reply
Newbie
Posts: 2
Registered: ‎09-15-2016

Re: lanyard or tether able to attach to the tiny wire loop on Cruzer Fit 32GB

One with a thin very strong loop that's long enough .using a old Sandisk one myself.

 

20160916_003506.jpg

Newbie
Posts: 1
Registered: ‎11-16-2016

Re: lanyard or tether able to attach to the tiny wire loop on Cruzer Fit 32GB

Coated wire, 24 gauge, made in the US by Darice, available in Canada, used in crafting is small enought to go throught the loop, wind and bind the ends and attach a standard lanyard.  Necessity is the mother of invention!

 

Newbie
Posts: 1
Registered: ‎03-29-2017

Re: lanyard or tether able to attach to the tiny wire loop on Cruzer Fit 32GB

 Oh Ed, if only we were all know it alls like you.

 

I have two of those SanDisk drives and also have not even attempted to get a lanyard through that hole. The last picture I see in this thread is not the same drive. The hole pictured is considerably larger.

 

I thought about it for a minute and think if I was going to do it I would try using a lanyard like the one pictured and thread it through the hole like you would thread a needle ... with one of those helpers. Let me know if it works.

needle helper.jpg
Newbie
Posts: 1
Registered: ‎10-09-2017

Re: lanyard or tether able to attach to the tiny wire loop on Cruzer Fit 32GB

I've had the same problem... my solution:  push the cord into the "too small" opening; then fish it out the other side with a pin - straight pin, needle, safety pin - whatever pin you have handy.

Highlighted
Newbie
Posts: 1
Registered: ‎05-14-2019

Re: lanyard or tether able to attach to the tiny wire loop on Cruzer Fit 32GB

I use a single strand of copper wire from a old cable .

1. You simply feed the strand through the hole in the usb fit.

2.  Feed the lanyard loop onto the wire

3. Feed the wire strand back through the hole & pull the lanyard loop into the usb hole.