The instructions for "DownloadSanDiskSecureAccess_Mac say, “minimum system requirements are: Mac OSX V 10.6+.”
My MAC is running MacOS 10.6.8, so it should work.
But when I install SanDiskSecureAccessV3_mac on my SanDisk Ultra USB 3.0 256GB flash drive (per instructions) and then launch the program from the flash drive, I always get this Mac Problem Report:
“SanDiskSecureAccessV3_mac quit unexpectedly.” The following info is provided in the report:
Exception Type: EXC_BAD_ACCESS (SIGSEGV)
Exception Codes: KERN_INVALID_ADDRESS at 0xfffffffffffffff8
Crashed Thread: Unknown
Backtrace not available
Unknown thread crashed with X86 Thread State (64-bit):
rax: 0x0000000000000055 rbx: 0x0000000000000000 rcx: 0x0000000000000000 rdx: 0x0000000000000000
rdi: 0x0000000000000000 rsi: 0x0000000000000000 rbp: 0x0000000000000000 rsp: 0x0000000000000000
r8: 0x0000000000000000 r9: 0x0000000000000000 r10: 0x0000000000000000 r11: 0x0000000000000000
r12: 0x0000000000000000 r13: 0x0000000000000000 r14: 0x0000000000000000 r15: 0x0000000000000000
rip: 0x00007fff5fc01028 rfl: 0x0000000000010203 cr2: 0xfffffffffffffff8
Has anyone else had this problem?