My Sansa crashed??

I don’t know what happened, but I was going to charge my Sansa Fuze and when I plugged it into my computer, it suddenly froze and didn’t move. I tried to turn it off, but it didn’t even do that, so I just let the battery run out. Now, even though I plug it into my computer, the screen remains black and it refuses to turn on. What is this???

  1. Reset you Fuze. Hold the power sliding switch up for 20 - 30 seconds. Release, then it should start up normally.
  2. This is the Sansa Medai Caonverter board. Your question really should have been posted in the Fuze board.
  3. With all the instances of the same question being asked in the Fuze board, you probably didn’t even need to post this and have to wait for an answer. 5 minutes of looking and/or searching would have yielded the same solution.

:smiley:

  1. Reset you Fuze. Hold the power sliding switch up for 20 - 30 seconds. Release, then it should start up normally.
  2. This is the Sansa Medai Converter board. Your question really should have been posted in the Fuze board.
  3. With all the instances of the same question being asked in the Fuze board, you probably didn’t even need to post this and have to wait for an answer. 5 minutes of looking and/or searching would have yielded the same solution.

:smiley:

  1. Reset you Fuze. Hold the power sliding switch up for 20 - 30 seconds. Release, then it should start up normally.
  2. This is the Sansa Media Converter board. Your question really should have been posted in the Fuze board.
  3. With all the instances of the same question being asked in the Fuze board, you probably didn’t even need to post this and have to wait for an answer. 5 minutes of looking and/or searching would have yielded the same solution.

:smiley: