I’ve been away for awhile (mainly because I lost my trusty v1 Fuze). Anyways, finally got up to ordering a Fuze, and this one’s a v2. It came with the .26 firmware, and I charged it up then upgraded to .33 . I turned it on to make sure the firmware upgrade worked, and it came on just fine, so I plugged it in and the screen went blank. I tried the usual soft reset (holding the power button in the on position for varying amounts of time, anywhere from 10 seconds to a full minute), which has always fixed this problem with my v1, but upon trying to power up the v2, nothing seemed to happen. I tried the soft reset at least five or so times. I even tried putting the power button in the Hold position and plugging in the v2 (twice, once without holding in the menu button and once while holding in the power button). These are the two solutions that I did with a not-so-thorough search. I’ll keep searching the forum, but if anybody has anything else I can try, I’d much appreciate the suggestion.