I can concur. My 128Gb Ultra Fit runs too hot as well. To the point where it begins to disconnect and reconnect constantly. The only solution is to cool the drive down and resume operations. However it only takes around 5 minutes of copying before it begins to exhibit problems.
I’ve tried blowing cool air regularly into my USB hub and it appears to remove the disconnect issue, which clearly shows that this is a heat issue.
I’ve tried the drive in both a USB hub and directly on the ports on my motherboard. They both cause it to fail eventually.
Not good Sandisk. Perhaps I got a faulty drive - I hope so - otherwise that’s just poor design and testing.
